1601 Parking Control
BARRIER GATE OPERATOR
High Usage Single Lane Traffic Control
- Designed for single lane (14 ft maximum) vehicular control in high traffic applications
- Electronic Limit Settings
- Operators are designed so that they can be mounted on either the left or right hand side of the roadway
- Lighted and Breakaway Arm Kits available. Low headroom Folding Arm Kits also available
- Pedestrian Protection System available
- 5-Year Limited Warranty
Breakaway Arm Option
reduce maintenance costs
Pedestrian Protection System Available
it’s aware – even when they’re not
Octagonal Lighted Signal Arm Option
light the way for customers to exit easily and safely with signals and sensors
WARN Beeper / Operate Beeper
The beeper will beep two times before lowering the arm when the timer times out. When the down-loop is activated, it will cancel the timer and lower the arm without beeping
ACCESS CONTROL SOLUTIONS
- These operators use a step-down transformer to achieve 115 VAC operating voltage.
- Optional factory installed DC powered drive system provides an automatic method to open the gate when primary (AC) power fails.
- Breakaway Arm available with aluminum arm type only.
- This will be two-piece aluminum arm (reduces shipping cost).
- Maximum length of arm when using a folding arm kit is 12 ft.
TECHNICAL FEATURES
MECHANICAL
Primary Reduction is provided by a 60:1 Worm Gear Reduction System running in a continuous oil bath
Arm rotates 90° in approximately 2.5 seconds
G90 Galvanized Steel Housing
Fail-Secure Mechanical Release Method
Left- or Right-Hand Mount
360° gear box rotation before the motor changes direction.This provides for smooth operation, evens wear across the entire gear-box, and increases the life span of the operator
GATE TRACKER™
Reporting output provides operator data to a
DKS 1833, 1835, 1837 or 1838 access control system
(requires 2358 expansion board)
Options
Aluminum Octagonal Lighted Barrier Arm: Octagonal Arm LEDs are RED when the arm is in the down position and turns to GREEN when the arm rotates to the full up position.
Breakaway Hardware Kit: Allows arm to swing out of the way in the event that a vehicle fails to stop at a lowered Arm. The system is easily reset by simply snapping the Arm back into place. For Aluminum Arms only.
2-Piece Arm 14 Ft (4.27 m): The two-piece Aluminum Arm ships in a 7 ft (2.13 m) long box to reduce shipping cost. Two-piece design does not accept light kit.
Electrical
Magnetic Electronic Limit Controls
Auto-Close timer 3.5 to 59 seconds
P.A.M.S. (Perimeter Access Management System) sequence with a Slide or Swing Gate Operator
Up Input Memory Buffer
Down Memory Option
Multiple Up Commands
Port for plug-in Open (Up) Detector
Port for plug-in Reverse (Down) Detector
Programming Switches
Built-in Power On/Off Switch
Built-in Selectable Warning Beeper
DKS Pedestrian Protection System: The system reverses Barrier Arm if person is detected, and lowers
Barrier Arm if unauthorized vehicle enters. Requires DKS
9411 Loop Detector and a photo-beam.
Miscellaneous
Environmental: 10°F to 140°F (-12°C to 62°C)
Thermostatically Controlled Heater Kit recommended for colder environments.
1601 shipping weight approximately 140-160 lb (63-72 kg)
Arm Kit: 15 lb (7 kg)
DOORKING, INC.
Access Control Solutions since 1948
120 Glasgow Avenue, Inglewood, California 90301 U.S.A.
Tel: 310-645-0023 FAX: 310-641-1586
www.doorking.com
© 2025 All Rights Reserved. Product specifications may change without notice. Rev. 2/25
MEMBER:
