1601 Parking Control

By /

1601 Parking Control

BARRIER GATE OPERATOR

High Usage Single Lane Traffic Control
  • Designed for single lane (14 ft maximum) vehicular control in high traffic applications
  • Electronic Limit Settings
  • Operators are designed so that they can be mounted on either the left or right hand side of the roadway
  • Lighted and Breakaway Arm Kits available. Low headroom Folding Arm Kits also available
  • Pedestrian Protection System available (See back page for system requirements)
  • 5-Year Limited Warranty
%%tb-image-alt-text%%
Breakaway Arm Option

reduce maintenance costs

%%tb-image-alt-text%%
Pedestrian Protection System Available

it’s aware – even when they’re not

%%tb-image-alt-text%%
Octagonal Lighted Signal Arm Option

light the way for customers to exit easily and safely with signals and sensors

%%tb-image-alt-text%%
WARN Beeper / Operate Beeper

The beeper will beep two times before lowering the arm when the timer times out. When the down-loop is activated, it will cancel the timer and lower the arm without beeping

ACCESS CONTROL SOLUTIONS

 

  1. These operators use a step-down transformer to achieve 115 VAC operating voltage.
  2. Optional factory installed DC powered drive system provides an automatic method to open the gate when primary (AC) power fails.
  3. Breakaway Arm available with aluminum arm type only.
  4. This will be two-piece aluminum arm (reduces shipping cost).
  5. Maximum length of arm when using a folding arm kit is 12 ft.

TECHNICAL FEATURES

MECHANICAL

System running in a continuous oil bath
Arm rotates 90° in approximately 2.5 seconds
G90 Galvanized Steel Housing
Fail-Secure Mechanical Release Method
Left- or Right-Hand Mount
360° gear box rotation before the motor changes direction.This provides for smooth operation, evens wear across the entire gear-box, and increases the life span of the operator

GATE TRACKERTM

Reporting output provides operator data to a
DKS 1833, 1835, 1837 or 1838 access control system
(requires 2358 expansion board)

Options

Aluminum Octagonal Lighted Barrier Arm: Octagonal Arm LEDs are RED when the arm is in the down position and turns to GREEN when the arm rotates to the full up position.
Breakaway Hardware Kit: Allows arm to swing out of the way in the event that a vehicle fails to stop at a lowered Arm. The system is easily reset by simply snapping the Arm back into place. For Aluminum Arms only.
2-Piece Arm 14 Ft (4.27 m): The two-piece Aluminum Arm ships in a 7 ft (2.13 m) long box to reduce shipping cost.
Two-piece design does not accept light kit.

Electrical

Magnetic Electronic Limit Controls
Auto-Close timer 1-23 seconds
P.A.M.S. (Perimeter Access Management System) sequence with a Slide or Swing Gate Operator
Up Input Memory Buffer
Down Memory Option
Multiple Up Commands
Port for plug-in Open (Up) Detector
Port for plug-in Reverse (Down) Detector
Programming Switches
Built-in Power On/Off Switch
DKS Pedestrian Protection System: The system reverses Barrier Arm if person is detected, and lowers
Barrier Arm if unauthorized vehicle enters. Requires DKS
9411 Loop Detector and a photo-beam.

Miscellaneous

Environmental: 10°F to 140°F (-12°C to 62°C)
Thermostatically Controlled Heater Kit recommended for colder environments.
1601 shipping weight approximately 140-160 lb (63-72 kg)
Arm Kit: 15 lb (7 kg)

DOORKING,  INC.

Access Control Solutions since 1948

120 Glasgow Avenue, Inglewood, California 90301 U.S.A. 
Tel: 310-645-0023   FAX: 310-641-1586
www.doorking.com

© 2024 All Rights Reserved. Product specifications may change without notice. Rev. 5/24

MEMBER:

National Apartment Association
Door and Access Systems Manufactures Association International
Scroll to Top
Skip to content