9024

1 Assumes gate is on level ground, in good condition with properly adjusted hardware. 2 Assumes a 16 ft gate weighing 1000 lb. Other external factors (temperature, charge state of batteries, gate weight, gate length, etc.) will affect the performance of the Gate Operator and may reduce the number of cycles shown.

“T-Handle” release

OPTIONS

AC/DC SLIDE GATE OPERATOR

Easy To Use

DC SLIDE GATE OPERATOR BATTERY BACK-UP & SOLAR POWER

Quadra Drive DC Motor

Adjustable Partial Open Limit Easy Adjustable Chain Driven Limit Nuts Auto-Close Timer 1-30 seconds Selectable Loop / Reverse input function; stop or reverse Anti-Tailgating feature helps to control un-authorized traffic Standard Normally Closed Stop Circuit DC Power Shut-Off switch Battery Protection Circuit Ports for plug-in open and reverse loop detectors (DKS plug-in detectors only) AC Powered Operator Only 115 VAC Convenience Outlets AC Power Shut-Off switch DC Powered Operator Only 0.0 Amp SBPDPatPend Circuit

TAP HERE FOR PRINTER VERSION

ELECTRICAL

Access Control Solutions since 1948

Environmental: -10°F to 140°F (23°C to 62°C) Thermostatically Controlled Heater Kit required for operation below freezing temperatures to prevent batteries from freezing. Heater kit can only be used with AC powered operators. Operator requires Type B1 or Type B2 entrapment protection devices in each direction of travel, otherwise the operator will not function. Shipping weight approximately 130-150 lb (59-68 kg) depending on model and options selected.

9024 VEHICULAR

for longer life

The 9024 can run exclusively on AC power with battery backup, or solely on solar power. Operator is 24 Volt DC and includes built-in Battery Backup 115/230 VAC (switch selectable) or 24 VDC Solar Power 1/2 HP Quadra Drive Heavy-Duty DC Motor Adjustable Limit Nuts for precise gate limit control Easy to use manual T-handle release Heavy-Duty Gearbox 0.0 Amp SBPD Circuit (solar power only) Solar Power ready Pad or Post mount Heavy-Duty Steel Frame 5-Year Limited Warranty

Frame: 3/16 Steel, corrosion protected Cover: 1/4 inch Polypropylene Reduction: Belt Driven 30:1 gear reduction running in a continuous oil bath Speed: Approximately 1 ft/sec (30.5 cm/sec) Chain: Unit is shipped with 20 ft of #40 roller chain Manual Release: “T-Handle” release is easily accessible from front of operator. Operator re-connects automatically when handle is released

MECHANICAL

Gate Tracker

Heater kit for cold weather environments (only used with AC powered operator) Steel Base plate for post mounting 18 Ah batteries (AC powered operator only) Solar Kit (Includes two 18 Ah batteries and 10 Watt, 24 VDC solar panel)

TECHNICAL FEATURES

GATE TRACKER

MISCELLANEOUS

reporting output

RESIDENTIAL • COMMERCIAL

heavy-duty 30:1 ratio gearbox

MEMBER:

Full Size Gearbox

Reporting output provides operator data to a DKS 1833, 1835, 1837 or 1838 access control system (requires 2358 expansion board)

DOORKING, INC.